Topic: GAS PEDAL SPRING REPLACEMENT
in Forum: C3 Interior
Already a Member?
Click Here to Login
Not yet a Member?
Click Here to Register for Free!
Former Member
Send PM
Canada
Joined: 3/9/2008
Posts: 164
Vette(s): 70 VETTE 350/300HP, AUTOMATIC, ALL STOCK EXCEPT FOR MILD CAM,LAGUNA GREY, 3:55 POSI GEARS
Has anyone replaced this before, what are the steps or has anyone have pictures,
just noticed mine does not kick back up.
just noticed mine does not kick back up.
SPONSOR AD:: (Our Sponsors help support C3VR)
Former Member
Send PM
Canada
Joined: 3/9/2008
Posts: 164
Vette(s): 70 VETTE 350/300HP, AUTOMATIC, ALL STOCK EXCEPT FOR MILD CAM,LAGUNA GREY, 3:55 POSI GEARS
I believe there is a spring in behind the pedal. This keeps the accelerator pedal upright.
Lifetime MemberIt's been a while since I replaced mine (ok, installed it since it was missing). It's on the engine bay side. If I remember, getting the spring into the hole on the pedal shaft was a pain - or maybe it was the end on the firewall. Not too hard, just need a little patience. I'd post the picture from the AIM book but all my stuff is packed up in storage right now.
Former Member
Send PM
Canada
Joined: 3/9/2008
Posts: 164
Vette(s): 70 VETTE 350/300HP, AUTOMATIC, ALL STOCK EXCEPT FOR MILD CAM,LAGUNA GREY, 3:55 POSI GEARS
Your right John, it did take a little patience. Purchased a new spring, it was a little tricky to hold the pedal and the spring and at the same time slide the pin in back of the pedal to hold it all together.
in Forum: C3 Interior
SPONSOR AD: (Our Sponsors help support C3VR)