ok so my car ran great then I went to start it to go to work and no injector pulse.
I am getting volts to both injectors, fuses are ok, fuel pump fuse is ok, fuel pump relay reads voltage at all pins- swapped relay with known good from under hood tested no pulse from injectors, fuel pump- took out hooked up ground and tapped hot wire to it and it turns on. Ecm fuse good, New Battery, good connections at distributor... Have a full tank of fuel
So now what? I am at a loss- checking the ignition system is next ie making sure I have spark to wires, control module on top of distributor is pretty new, oil pressure sending unit is hooked up
put fuel in throttle bodies fires right up. dies when fuel is gone. injectors arent firing at all...Plugged fuel filters??
any thoughts any ideas that I missed?
thanks
marcus
after hours of searching the net for solutions, removing fuel pump and tracing all my wires I found this post
they say 20 amp fuse but mine is a 30 amp fuse. I will be replacing the entire unit in the morning to a more sealed unit.