Lifetime Member #116
Dave's '82
Where are the GM designated lift positions?
God Bless Our Troops!
Joel Adams
C3VR Lifetime Member #56
My Link
(click for Texas-sized view!) NCRS
"Money can't buy happiness -- but somehow it's more comforting to cry in a CORVETTE than in a Kia"
Wow, thank you if I lift in the front, should I support midway or rear?
God Bless Our Troops!
How you jack it up and support it depends on what you are going to be doing. If you are only working on the front end(suspension, tires/wheels, etc), put jack stands under the frame just behind the front wheels, where the diagram shows. If working on just the rear, jack from the SIDES at the rear positions on the diagram, and put jack stands in the same area. If raising the entire vehicle, what I do is put the jack almost center of the side(on the frame), about where the trans crossmember is, and jack the entire side up, and put jack stands where it shows on the diagram. Then, jack the other side up the same way, and insert the jack stands. You can jack one side of the car up completely with a jack(a good jack, that is) from the sides....done it hundreds of times with no issues at all.
Joel Adams
C3VR Lifetime Member #56
My Link
(click for Texas-sized view!) NCRS
"Money can't buy happiness -- but somehow it's more comforting to cry in a CORVETTE than in a Kia"
All of this is really helpful for me! Thank you guys! I really appreciate it.
mike
God Bless Our Troops!